Russound XStream X5 Installation Manual page 39

Installation Overview
Electrical Power
The XStream™ X5 operates at 100-120VAC ~60 Hz or 220-240VAC ~50 Hz. Voltage is selected
automatically by the power supply and the appropriate detachable power cord. It is recommended
that the XStream™ X5 and the source equipment be plugged into a dedicated 15-amp circuit. The
power switch for the unit is on the rear panel as shown.
Important Considerations
• Disconnect the power cord before making any connections to the controller.
• Verify that all connections and polarity are correct.
• Keep all power cords away from all signal cables to prevent humming from induced noise.
• Choose reliable signal cables and patch cords.
• Label all wires with the room location at both ends of the wire.
• Avoid running speaker wires or signal cables close to house electrical wiring for any distance. If
you have to run them parallel, make sure to space the wires at least two feet from the AC line. If
you need to cross an AC line it should be at a 90° angle.
Do not connect the controller's main power feed until all other connections
have been made and verified. Live connection or removal of the keypad
wiring or other wiring when the system is powered can cause
communication problems in the network. Double-check terminations during
each phase of the installation to prevent accidental damage. Incorrect wiring
is the number one cause for non-warranty product damage.
39