Ir Receiver Connection; Making Connections - Russound CAV6.6-S2 System Instruction Manual

INSTALLER
UNO-S2 KEYPAD-INSTALLATION

IR Receiver Connection

The UNO-S2 keypad has an External IR Receiver
In terminal for connecting an external IR receiver
such as the Russound 858, SaphIR Eye, or
SaphIR Phantom. Use 2 twisted pair wire with
Back of
Russound 858
26
one pair connecting GND (GROUND) and IR (SIG-
NAL) and the other pair connecting ST (STATUS)
and V+ (+12VDC). If the wire has a shield, con-
nect it to ground at the UNO-S2 only.
Back of
UNO-S2
UNO System Keypad Port Connection
The UNO System Keypad Ports are located on
the back of the CAV6.6 in the top left corner.
Connections made at the UNO Keypad Ports are
made using CAT-5 T568A RJ-45 wire configura-
tion. CAT-5 is color-coded for ease of installa-
tion. For a clean installation when wiring from an
UNO System Keypad Port use an RJ-45 CAT-5
patch cable to connect from the keypad port to
an RJ-45 Wall Plate (optional). Using the same
CAT-5 T568A RJ-45 wiring configuration, use
INSTALLER

MAKING CONNECTIONS

CAT-5 from the RJ-45 Wall Plate to the keypad.
If using more than one keypad on a zone, con-
nect a SA-ZX3 UNO System Keypad Splitter
(optional) directly to the UNO System Keypad
Port instead of going through the wall plate.
Always use the CAT-5 T568A RJ-45 wire configu-
ration when wiring any of the UNO System
Keypad Ports.
(See Sample System Configuration 3, page 76)
27