Setting Up X5 - Russound XStream X5 Installation Manual

Setting Up XStream X5
1. Unpack the X5 and all of its contents:
1 X5 Controller Streamer Amplifier
1 Power cord
2 Wi-Fi antennas
1 IR emitter
2. Screw the two antennas on the antennae posts as shown
3. Remove the detachable speaker connector from the X5
4. Strip back 1/8" of the insulation on the speaker wire and twist the end of each wire to tighten the
bundle of copper strands on each wire.
Snap connector
5. Place the stripped end of the wire into the appropriate terminal and collapse the latch. Check
to make sure there are no strands of copper showing and check the security of the wire in the
connector. Between each terminal, take caution to not let the wire fray or touch another connection.
6. Connect the other end of the wire to each speaker.
7. Re-connect the detachable speaker terminal.
Speaker wires
Be careful to maintain polarity.
28