Rimage Everest 600 User Manual page 23

Maintaining the Everest 600 Printer
Change the Retransfer Ribbon
Before you change or first install the Everest 600 retransfer ribbon, allow
time for the new ribbon to become acclimated to the environment. Allow
more time for greater temperature and humidity differences.
Important!
Rimage supports only the use of Rimage brand ribbons in our printers.
•
Printer issues that occur as a result of using ribbons by manufacturers
other than Rimage are not included under your Rimage warranty or
maintenance agreement.
For optimum results, make sure that Everest 600 ribbons are stored at a
•
temperature between 41° and 95°F (5° to 35°C) and humidity level
between 45% and 85%.
Avoid moisture and direct sunlight.
•
Do not reuse ribbons.
•
Make sure you only use ribbons designed for the Everest 600 printer.
•
Remove the Retransfer Ribbon
1. Open the side cover.
a. Press the two side cover latches to release the side cover.
b. Lower the side cover.
Side Cover
2001474_B
Side Cover Latches
For more information visit
2. Remove the used retransfer ribbon.
Retransfer
Ribbon Carrier
Latch 1
a. Open latches 1, 2, and 3.
b. Grasp the handle to slide the retransfer ribbon carrier out of the
printer.
Tip: The retransfer ribbon carrier cannot be removed from the
printer.
c. Lift the retransfer rolls out of the carrier.
d. Carefully slide the retransfer ribbon from the retransfer ribbon
carrier.
e. Discard the used retransfer ribbon.
rimage.com/support
Retransfer
Rolls
Latch 3
Latch 2
20