Rimage Everest 600 User Manual page 28

Maintaining the Everest 600 Printer
6. Prepare the printer for use.
a. When the air filters are dry, position them on the inside of the fan
cover.
b. Make sure that the tabs on the fan cover fit into the holes in the
side cover.
c. Open the side cover.
d. Insert and tighten the Torx T10 screws (Qty. 4) to secure the fan
cover to the side cover.
e. Close the side cover and the attached fan cover.
The printer is ready for use.
Clean the Platen Roller
Important! Clean the platen roller only if you notice a diminished print
quality, such as white specks on the printed disc.
Tools required:
#
• Sponge swabs with long handles (included in the Everest
Cleaning Kit)
• 99% Isopropyl alcohol
2001474_B
Tabs
Side Cover
Fan Cover
For more information visit
1. Prepare to clean the platen roller.
a. Power off the printer.
b. At the back of the printer, turn the mode switch to position 3
(diagnostic mode).
c. Power on the printer.
2. Access the platen roller.
Print
Ribbon Carrier
Latch 1
a. Press the two side cover latches to release the side cover.
b. Lower the side cover.
rimage.com/support
Retransfer
Ribbon Carrier
Latch 3
Latch 2
25