Warnings And Recommendations - Wilson Electronics 801101 Installation Manual

Warnings and Recommendations

Warning: In a wireless installation, do not plug the signal booster directly into the
cell phone or cellular data card using an antenna adapter . It will damage
the cell phone or cellular data card .
Warning: Do not install the inside antenna within 4 inches of metal . (Metal found
inside the vehicle's seat will not affect antenna performance .)
Warning: Do not use any type of glass-mount antenna with this signal booster .
The outside and inside antennas must be shielded from each other to
prevent oscillation .
Warning: Do not plug in the DC power supply until the outside and inside antenna
cables are attached to the signal booster .
Warning: RF Safety: The inside antenna must be installed with a separation of at
least 8 inches from all persons and must not be located in conjunction
with any other antenna or signal booster .
Warning: RF Safety: The outside antenna must be installed with a separation
of at least 20 inches from any of the vehicle's occupants or nearby
persons and must not be located or operating in conjunction with any
other antenna or signal booster . All roof-mount antennas should be
centrally located on the roof of the vehicle . Mirror-mount antennas
should mounted as high above the roof line as possible and leave at
least 20 inches of separation from any persons near or around the
vehicle . Use of a cellular signal booster with an antenna gain higher
than 5 .12 dBi is in violation of FCC regulations for which the offender is
fully liable . All Wilson Electronics mobile antennas are 5 .12 dBi or less
in the 800 MHz band .
Warning: The inside antenna must be installed with a separation of at least 8
inches from all persons and must not be located in conjunction with
any other antenna or signal booster .
7
Contact Wilson Electronics Tech Support with any questions at 866-294-1660
Or email: tech@wilsonelectronics.com Hours: 7am to 6pm MST.