Table of Contents
Advertisement
2
Press TUNING MODE repeatedly until
"AUTO" appears.
3
Press TUNING + or –.
The frequency indication changes and the
scanning stops when the system tunes in a
station. "TUNED" and "ST" (for a stereo
programme) light up.
If "TUNED" does not light up
and the frequency indication
does not stop changing
Press TUNING MODE repeatedly until
"AUTO" or "PRESET" disappears, then
press TUNING + or – repeatedly to tune in
the desired station.
4
Press MENU/NO on the remote.
5
Press . or > on the remote
repeatedly until "P.Memory ?" appears,
then press ENTER/YES on the remote.
A preset number appears in the display. The
stations are stored from preset number 1.
6
Press ENTER/YES.
"Complete !!" appears, and then the station is
stored.
7
Repeat steps 1 to 6 to preset other
stations.
To stop scanning
Press TUNING MODE.
To tune in a station with a weak
signal
Press TUNING MODE repeatedly until "AUTO"
or "PRESET" disappears in step 2, then press
TUNING + or – repeatedly to tune in the station
manually.
To set another station to the
exist preset number
Start over from step 1. After step 5, press . or
> on the remote to select the preset number you
want to store the other station.
You can add a new preset number after the last
preset number.
To erase a preset station
1 Press MENU/NO on the remote.
2 Press . or > repeatedly until "P.Erase ?"
appears.
Select "P.All Erase ?" when you want to erase
all the preset stations.
3 Press ENTER/YES on the remote.
4 Press . or > repeatedly to select the
preset number you want to erase.
5 Press ENTER/YES.
"Complete !!" appears.
When you erase a preset number, the preset
number decreases by one and all preset numbers
following the erased one are renumbered.
To change the AM tuning
interval
Preset number
The AM tuning interval is factory-set to 9 kHz (10
kHz in some areas). To change the AM tuning
interval, tune in any AM station first, then turn off
the system. While holding down the TUNING
MODE button, turn the system back on. When
you change the interval, all the AM preset stations
are erased. To reset the interval, repeat the same
procedure.
Tips
• The preset stations are retained for about a day even
if you disconnect the mains lead or if a power
failure occurs.
• You can label the preset stations (see page 45).
7
Advertisement
Table of Contents
