Connection With The Mains - Omnitronic PAM-500 MK2 User Manual

6.5 Foot Switch
Via a footswitch the internal echo effect can be switched on and off. Connect the foot switch with a 2-pole
6.3 mm plug to the jack FOOT SWITCH.

6.6 Connection with the Mains

Connect the supplied power supply cable to the corresponding input and the mains plug to an outlet (230 V
AC, 50 Hz ~). The amplifier can also be operated with 115 V AC, 60 Hz ~. For this purpose, set the voltage
selector switch to the 115 V position. The occupation of the connection cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
The earth has to be connected! If the device will be directly connected with the local power supply network, a
disconnection switch with a minimum opening of 3 mm at every pole has to be included in the permanent electrical
installation. The device must only be connected with an electric installation carried out in compliance with the IEC
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum fault current
of 30 mA.
International
L
N
30/34 00073641.DOC, Version 1.0