Outputs; Information On Installing Audio Cables; Connection With The Mains - Omnitronic AS-800 User Manual

6.2 Outputs

Connect the satellite speakers to the speaker connectors of the subwoofer using the included
1
connection cables. For locking the connection turn the plug to the right. For unlocking pull the unlock
button and turn the plug to the left and pull it out of the socket.
At the balanced XLR outputs LINK the input signal fed through is available. This output allows
2
connecting the input of another active speaker system for additional PA applications.
Connection Speaker socket

6.3 Information on installing audio cables

• Always treat cables carefully and protect them from damages during transportation.
• Install cables always in a structured way and protect them from damage.
• Cables must be installed in a way that no person can stumble over them. Always fix cables with an
appropriate tape.
• Cables should be installed directly (no loops, S-shaped overlengths).
• Always install cables far away from power cables (never closely parallel).
• Never put heavy objects like speaker systems, flightcases etc. on cables.
• Never operate cables wound up.

6.4 Connection with the mains

Finally, use the supplied power cable to connect the amplifier to the mains (230 V AC, 50 Hz ~). The
occupation of the connection cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
The earth has to be connected! If the device will be directly connected with the local power supply network, a
disconnection switch with a minimum opening of 3 mm at every pole has to be included in the permanent
electrical installation. The device must only be connected with an electric installation carried out in
compliance with the IEC standards. The electric installation must be equipped with a Residual Current
Device (RCD) with a maximum fault current of 30 mA.
International
L
N
28/31 00074230, Version 1.0