Operating Elements And Connections - Omnitronic PAM-500 MK2 User Manual

4. OPERATING ELEMENTS AND CONNECTIONS

4.1 Input Channels
1
Volume control LEVEL
2 Control VIP
To adjust the degree of level attenuation when
using the TALKOVER function with channel 1.
3 Equalizer
TREBLE (±12 dB/10 kHz),
MID (±12 dB/1 kHz),
LOW (±12 dB/100 Hz)
4
Control AUX
• Determines the level at which the channel signal
is fed to the internal effect processor and to an
effect unit connected to the jack REV/AUX SEND
and thus to define the effect intensity for the
channel. The level adjusted depends on the
adjustment of the channel level.
4.2 Tuner and Effect Section
6 Volume control for the tuner
7 Display
Indicates the receiving frequency.
8 Button RESET
For resetting to default settings FM 87.5 MHz and
stereo mode.
9
Button FM/AM with LED
For switching over between FM and AM reception.
The LED FM/AM lights when FM reception is
selected.
• In the MAIN MONITOR mode, this control is also
used to adjust the part of the channel for the
monitor signal.
5 Control PAN
• Mono input channels 1-4: The control places the
mono signal in the stereo sound of the master
signal.
• Stereo input channels 5/6 and 7/8: The control
adjusts the balance left/right for the stereo signal.
10 Button STEREO/MONO with LEDs
For switching over between stereo and mono mode.
The LEDs STEREO/MONO and STEREO light
when stereo mode is selected.
11 Buttons [ ] and [ ]
For station tuning
• Long actuation: starts automatic station finding in
forward or backward direction
• Short actuation:
increased or reduced step by step
22/34
the received frequency
00073641.DOC, Version 1.0
is