BIOS errors and warnings
The BIOS generates warnings/errors on invalid memory configurations:
If the BIOS can find a valid memory configuration by disabling plugged-in memory, it does so and
●
reports a warning during POST. The workstation can still be started. The warning will indicate the
location of the failed DIMM on the system board.
●
If there is no way for the BIOS to obtain a valid memory configuration by disabling plugged-in memory,
the BIOS halts with a diagnostics 2006 code for memory error (five beeps and blinks).
DIMM installation guidelines
●
Install only HP-approved DDR3 DIMMs
CAUTION:
Because third-party DIMMs might not be electrically or thermally compatible, they are not supported by
HP.
●
For ECC DIMMs, use only industry-standard ECC unbuffered DIMMs. Go to
quickspecs
●
Do not intermix non-ECC memory DIMMs with ECC memory DIMMs.
CAUTION:
DIMMs and their sockets are keyed for proper installation. To prevent socket or DIMM damage,
align these guides properly when installing DIMMs.
DIMM installation order
Install DIMMs in this order.
CAUTION:
Internal components might be powered even when the computer is off. To prevent damage,
disconnect the computer power cord before you remove or install a component.
HP ships only DIMMs that are electrically and thermally compatible with this computer.
to find which DIMMs are compatible with the computer.
http://www.hp.com/go/
Component replacement guidelines
43