Appendix; Maintenance; Questions And Answers - Siemens gigaset 4010 Operating Instructions Manual

Appendix

Appendix

Maintenance

Simply wipe the base station and handset with a damp cloth or an
antistatic wipe. Never use a dry cloth as this can cause static dis-
charge.
Contact with liquid
If the handset should come into contact with liquid,
on no account switch the device on.
Remove all batteries immediately.
Allow the liquid to drip out of the device, and then dab all parts of the
device dry.
Keep the handset with the batteries removed in a warm, dray place for
at least 72 hours. In many cases, you will then be able to use it again.

Questions and answers

If any questions occur to you while you are using your device, we are
available 24 hours a day at www.my-siemens.com/customercare.
You will find the most frequently asked questions and answers below.
Question
No display
No reaction to key-
stroke
No radio connection to
the base station – E.g.
base station 1 is flash-
ing
Handset that is in the
base station is not
charging
Handset does not ring
74
!
Possible cause
Handset not activated
Batteries empty
Keypad protection acti-
vated
Handset outside the
base station range
Handset not registered
Base station not activat-
ed
Line seized by a second
handset for a long peri-
od
Ringer off
Possible solution
Hold down end call key

for 1 second
*
Charge or replace the
batteries (page 9)
Hold down the
key for 1 second
Move closer to the base
station
Register the handset
(page 49)
Check the connector at
base station (page 8)
Maximum charging
power is only possible
while nobody is mak-
ing calls
+
Activate the ringer
Hold down the
key