Operating The Cleaner With The Remote Control (3510 Wd Only); Synchronizing The Remote Control - Zodiac 3000 wd Owner's Manual

Zodiac 3000 WD, 3010 WD, & 3510 WD Robotic Pool Cleaner
®
Figure 19. Keep Cleaner Vertical to Drain Water
4.7 Operating the Cleaner with the
Remote Control (3510 WD only)
The Zodiac 3510 WD robotic cleaner comes with a
handheld remote control stored on the cleaner caddy
next to the control unit. The remote control is factory-
synchronized to your cleaner's control unit.
ON/OFF
button
Figure 20. 3510 WD Remote Control
• To turn on the remote control:
Press (see Figure 20) and hold for 3 seconds.
The display shows
cleaner is now operating in remote control mode.
• To pilot the cleaner, point the device toward the
cleaner in the water and move directionally as shown
in Figure 21.
3
Lift System
button
to indicate the
|
Owner's Manual
Forward
Turn Left
Backward
Figure 21. Remote Control Directional Commands
• To remove the cleaner from the pool using the remote
control, press (see Figure 20).
4.8

Synchronizing the Remote Control

Even though the remote control is factory-synchronized
to your cleaner's control unit, it may be necessary to
synchronize again if you need to replace either the
control unit or the remote control.
• To synchronize the remote control to the control unit:
Press and hold for 3 seconds to turn on remote.
Plug the control unit into a power source.
When the display shows the operating time, press
and simultaneously for six (6) seconds.
• The display shows
normal operating time display to indicate the cleaner
is now synched with the remote and ready to begin
operating in remote control mode.
ENGLISH Page 13
Stop
Turn Right
followed by the