Section 3. Operation; Submerging The Cleaner; Cleaner Control Box - Zodiac CX35 Owner's Manual

Section 3. Operation

To prevent damage to the cleaner, be sure to adhere
to the following guidelines:
• Remove the cleaner from the pool after the
cleaning cycle is completed and store out of direct
sunlight or inclement weather.
• Take additional care when lifting the cleaner out of
the pool. It becomes heavier when filled with water.
• Always remove the cleaner from pool before adding
chemicals, such as chlorine or acid.
• Do not handle cleaner while it is in operation.
IMPORTANT
• Always make sure the cleaner head is fully
submerged before you begin operation.
• Clean the filter canister after each cleaning cycle.
• Do not leave your cleaner in the pool on a permanent
basis.
• At the end of each cycle, remove the cleaner from
the pool. Start at the cleaner head and untangle any
coils in the cable before storing the cleaner.
3.1

Cleaner Control box

Surface Control
System (SCS)
for wall cleaning
(rough to smooth
surfaces)
Dirty Filter
Indicator
Cleaner Error
Indicator
Select Cleaning Surface
• Floor
• Floor and Walls
8
CAUTION
ROUGH
• The pool cleaner is so efficient that it is not
necessary to run more than three cycles per week.
• The cleaning cycle can be customized at any time,
before the cleaner starts or while it is operating.
The Zodiac
®
that automatically stops the cleaner if it is powered on
but not submerged in water. For pools equipped with a
beach area, this safety feature is programmed to drive
the cleaner in reverse and back into the pool when the
impeller is out of the water.
3.2

Submerging the Cleaner

1. Submerge cleaner vertically (1) and hold it
under the surface, moving gently from side to
side (2) until the bubbles stop to remove any air
trapped inside (Figure 12).
2. When the bubbles stop, allow the cleaner to
sink to the bottom of the pool.
3. Verify the cleaner is sitting on the bottom
of the pool. Remove additional air if the cleaner
is still floating.
NOTE: The cable side of the cleaner remains up as long as
the cleaner fan motor is OFF. As soon as you turn the
cleaner ON, the handle lowers.
SURFACE CONTROL SYSTEM
1 2 3 4
SMOOTH
H0574000_REVA
robotic cleaner includes a safety feature
LEDs indicating
pump strength for
SCS
Start/Stop
Cleaner
Cleaning Cycle
Duration