Checklists For Completion Prior To Installation; Product Configuration; Location - HP StoreOnce 4900 Backup Installation And Configuration Manual

1 Checklists for completion prior to installation

Use the following checklists to ensure that:
You know the location, power and networking/fibre channel requirements of the product at
the time of placing the order.
You have prepared the environment and the information that you or the service specialist
requires to install and configure your system.

Product configuration

Table 1 Product configuration
Verify the delivered materials match the Bill of Materials (BoM) and that there is no damage to boxes
or components.
Purchase information
Products/Licenses Purchased
Check the Sales Order to verify licenses, cables, SFPs, and so on, were ordered for any of the
following additional items, as required:
Capacity upgrades and licenses
Replication and StoreOnce Catalyst licenses
Security Pack license
Additional cabling requirements and make sure they are pre-laid

Location

Before placing an order, consult the product specification, available at
StoreOnce, and identify a suitable location in your data center with sufficient access and space
to install the product.
The installation location must provide:
Suitable rack(s) with enough space to mount the hardware.
NOTE:
at the front of the rack to ensure that there is enough clearance to maneuver the disks in and
out of drawer 2.
Appropriate power, air conditioning, cabling, and fire protection.
Adequate protection from electrostatic discharge (ESD).
Adequate protection from electrical/radio frequency interference.
6 Checklists for completion prior to installation
Quantity
Sufficient space, at least 12 inches (30 cm), must be available to the right-hand side
Capacity
http://www.hp.com/go/