HP StoreOnce 4900 Backup Installation And Configuration Manual page 52

Do you want to configure a static default gateway for this subnet or get the gateway information from
DHCP?
1 = Gateway obtained from DHCP server (default)
2 = Set gateway manually (this may be blank if no gateway is required)
-->2
<--Gateway: Set gateway manually (this may be blank if no gateway is required)
-----------------------------------------------------
Note that if you intend to select this network as the
default network later on, then you must now specify
an IP address.
If, on the other hand, you do not intend to have a
default network, then you may not specify any
gateways for the system.
-----------------------------------------------------
Enter gateway IP address :
-->10.1.1.1
<--Gateway: 10.1.1.1
Do you want to configure the network domain name or get the domain name from DHCP?
1 = Static IPs entered, defaulting to empty Domain (default)
2 = Set domain name manually (e.g. mydomain.local - this may be blank if no domain name is required)
-->2
<--Domain Name: Set domain name manually (e.g. mydomain.local - this may be blank if no domain name is
required)
Enter domain name :
-->rnd.mycompany.net
<--Domain name: rnd.mycompany.net
----------------------
Network: subnet_2
----------------------
IP Addresses: 10.1.1.16
Net Mask: 255.255.255.0
Domain Name: rnd.mycompany.net
Gateway: 10.1.1.1
VLAN tag: 22
Port Set: portset_2 with these interfaces: eth4 eth5
Encryption Links:
Bonding Mode: 4 (Link Aggregate Control Protocol (LACP) Bonding)
Is this configuration correct?
1 = Yes (default)
2 = No
-->1
<--Configuration okay: Yes
3. At this point, you have configured the network sufficiently to enable access to the StoreOnce
Management CLI and GUI, and to target backup from media servers on the specified VLAN
subnet. We shall continue with the wizard to complete initial network configuration by creating
a third (and final) portset on a pair of 1GbE ports, eth2 and eth3, which will use bonding
mode 6 and, therefore, cannot be VLAN-enabled. This portset will be used for the StoreOnce
Catalyst Copy and Replication subnet, which will also be configured with the default Gateway.
-------------------------------------------------------------
If you have added all subnets, then you may proceed: you will
then be shown a summary of the configuration and be given the
option to validate it, and then a further option to apply it.
Otherwise, you may continue to add further subnets.
-------------------------------------------------------------
Do you want to configure another subnet?
1 = No (default)
2 = Yes - on a new physical port set
-->2
<--Another subnet: Yes - on a new physical port set
Select the type of configuration for this subnet
(Selecting "bonded" here will create a "portset" consisting of two separate NICs bonded together) :
1 = Single port (default)
2 = Bonded ports (note ports must be the same speed to bond)
-->2
<--Bonded/Single: Bonded ports (note ports must be the same speed to bond)
Select bond configuration :
1 = eth4, eth5 (10 Gig) (default)
-->1
52 Network configuration, how to use StoreOnce CLI commands