HP StoreOnce 4900 Backup Installation And Configuration Manual page 66

NOTE: When expanding capacity, additional pools are created for each set of disks. As there
is a separate Storage Cluster for each disk enclosure and associated RAID controller, the pools
under Storage Cluster 1 are expanded first. This is the first disk enclosure that is attached to the
RAID card in PCI slot 1 and the pools are identified from Pool (C1_P1) to Pool (C1_P6). The second
disk enclosure is attached to the RAID card in PCI slot 4 and the pools are identified from Pool
(C4_P1) to Pool (C4_P6) and listed under Storage Cluster 2. The status for the appropriate Storage
Cluster and Pool will show as Degraded until parity initialization completes.
1. Open the ssh application and log into the IP address for the StoreOnce Management Console
using the Administrator account.
2. Scan for the newly-attached storage and create the RAID volumes Logical Units (LUNs) using
the following StoreOnce CLI commands :
system show status hardware show storage status hardware discover
storage
NOTE:
specific values.
# system show status
Storage Set
---- ----– ---
Set 1
Service Sets Status
------------ ------
Set 1
#
#
# hardware show storage status
Storage Set
---- ----– ---
Set 1
#
#
# hardware discover storage
This command takes several minutes to complete execution.
storage discovery successfully completed
#
#
# hardware show storage status
Storage Set
---- ----– ---
Set 1
#
66 Completing the installation
The following output is an example; the values shown may not match your appliance
Status
----––
Formatted 34,876.99GB
Notes
-----
Running
Status
----––
Formatted 34,876.99GB
Status
----––
Formatted 34,876.99GB, Discovered 10,466.40GB to be added