Software Update Process; Upgrading Bios Or Hardware Firmware Components - HP StoreOnce 4900 Backup Installation And Configuration Manual

Use the appropriate commands to perform the required tasks.

Software update process

1. Identify the version of software currently installed on the system from the StoreOnce page of
the GUI or by using the StoreOnce CLI command, system show packages.
2. Locate the latest software on the HP Support pages — go to
and search for your product. If you need to upgrade, download the software, delivered as a
single RPM file.
IMPORTANT:
update instructions.
3. Using an SFTP application, sftp the package (<part_number>.rpm) to the repository
folder on the HP StoreOnce Backup system.
4. Open the puTTy (or other ssh) application, login to the StoreOnce CLI as an Admin user,
and enter the following CLI commands:
system show repository which should list out the rpm file you copied over
system load package <part_number>.rpm which will load and unpack the
package
system show packages which will show you the packages staged ready for update
NOTE:
D2D_Master-<software_revision_info>.rpm
system update packages which will begin the process to upgrade and reboot the
system
5. It may take up to 10 minutes for the software update to complete.
Once access returns to the StoreOnce Management interface, check that the process has
completed successfully, as follows:
From the CLI: Use system show packages to check that all packages are now
Installed. You should see this line in the output of system show packages: D2D_Master
<software_revision_info>.rpm installed
From the GUI: Check on the StoreOnce screen, to ensure that the software revision number
has updated to software version D2D_Master <software_revision_info>.
From the GUI: Check the Event log for a confirmation message of the software upgrade.
"Update D2D_Master <software_revision>" completed successfully.

Upgrading BIOS or hardware firmware components

Do not upgrade BIOS or hardware firmware components individually using downloads from the
HP Support website because currently supported firmware component updates are already
embedded within the StoreOnce software. Always use the StoreOnce CLI to implement BIOS and
hardware firmware component checks and updates.
Use hardware show firmware <node|storage> to check the versions currently running
on the StoreOnce Backup system. Check the Action column. There may be instances where
replacement hardware may need a firmware downgrade to bring it in line with the supported
firmware version of the installed StoreOnce software on the system being maintained. Use the
force parameter in the following command to enable this.
Use hardware update firmware <node|storage> [force] to implement any updates
that were packaged with the latest StoreOnce software download; there are two parameters
Always refer to the Release Notes accompanying the software for detailed
The name of the package once it is loaded and unpacked is in the format:
http://www.hp.com/support
Software update process 69