HP StoreOnce 4900 Backup Installation And Configuration Manual page 53

<--Bonding: eth4, eth5 (10 Gig)
Select the desired bonding mode :
-----------------------------------------------------------------
Note that if you select bonding mode 6, you will not subsequently
be able to add VLAN networks to this portset.
-----------------------------------------------------------------
1 = Mode 1 - Active Passive Bonding (default)
2 = Mode 4 - Link Aggregate Control Protocol (LACP) Bonding
3 = Mode 6 - Active Load Balance Bonding
-->2
<--Bonding Mode: Mode 6 - Active Load Balance Bonding
---------------------------------------------------
The next question has a mandatory response, since
this is a single-node system.
---------------------------------------------------
What type of data will this network carry?
1 = both (default)
-->1
<--Data/Management/Both: both
-------------------------------------------------------------
Portsets with bonding mode 6 may not have VLANs.
-------------------------------------------------------------
Is this subnet on a Virtual LAN?
1 = No (default)
-->1
<--VLAN/Not VLAN: No
Select Static or DHCP addressing :
1 = DHCP (default)
2 = Static
-->2
<--DHCP/Static: Static
No valid IP addresses to add.Enter an IP address for this network:
-->172.1.1.16
<--Static IP address: 172.1.1.16
Enter subnet mask :
-->255.255.0.0
<--Subnet mask: 255.255.0.0
Do you want to configure a static default gateway for this subnet or get the gateway information from
DHCP?
1 = Gateway obtained from DHCP server (default)
2 = Set gateway manually (this may be blank if no gateway is required)
-->2
<--Gateway: Set gateway manually (this may be blank if no gateway is required)
-----------------------------------------------------
Note that if you intend to select this network as the
default network later on, then you must now specify
an IP address.
If, on the other hand, you do not intend to have a
default network, then you may not specify any
gateways for the system.
-----------------------------------------------------
Enter gateway IP address :
-->172.1.1.1
<--Gateway: 172.1.1.1
Do you want to configure the network domain name or get the domain name from DHCP?
1 = Static IPs entered, defaulting to empty Domain (default)
2 = Set domain name manually (e.g. mydomain.local - this may be blank if no domain name is required)
-->2
<--Domain Name: Set domain name manually (e.g. mydomain.local - this may be blank if no domain name is
required)
Enter domain name :
-->uk.mycompany.net
<--Domain name: uk.mycompany.net
----------------------
Network: subnet_3
----------------------
IP Addresses: 172.1.1.16
Net Mask: 255.255.0.0
Network configuration using net set wizard 53