Advertisement
760mm.
M2 clevis.
790mm.
Control horn.
Metal clevis.
Elevator pushrod.
INSTALLATION TAILWHEEL.
1) Locate the pre-drilled hole in the bottom
of the rudder. This is the hole for the vertical
shaft of the tailwheel assembly.
www.seagullmodels.com
M2 lock nut.
Elevator pushrod.
M2 lock nut.
M3 x 15mm.
2) Temporarily mount the tailwheel
assembly to the bottom of rudder. Do not glue
at this time. Slide the nylon tailwheel support
brackets to be evenly spaced along the
tailwheel wire.
3) Mark where you drill the two locations
for the tailwheel support.
M3 x 15mm.
4) Drill through the bottom of the rudder
with the 2mm drill.
5) Using a toothpick insert a small amount
of the epoxy in the hole in the bottom of the
rudder. Insert the vertical tailwheel wire into the
hole with the epoxy and mount the nylon
brackets to the rudder with the hardware
included.
Epoxy.
21
Advertisement
