Galaxy Raid GHDX4 SAS<>SAS/ SATA 12Bay Installation / Hardware Reference Manual
Adjust Cable Strap Position
Step 5.
Attaching Power Cords
3.6
Power On
Once all of the disk drives have been properly installed and the I/O
ports or management interfaces have been connected, the
subsystem can be powered on.
Check List
BEFORE powering on the subsystem, please check the following:
3-10
Connect power cords to system power supplies and
insert the barb anchor into the anchor holes below the
power sockets.
CBM (optional): Make sure the CBM has been installed
correctly (if CBM has been purchased).
Hard drives: Hard drives have been installed in the drive
trays.