Table of Contents
Advertisement
23. If one of the following situations arises, get the enclosure
checked by service personnel:
a. Any of the power cords or plugs is damaged.
b. Liquid has penetrated into the system.
c. The enclosure has been exposed to moisture.
d. The system does not work well or you cannot get it to work
according to this manual.
e. The system has dropped and been damaged.
f.
The system shows obvious signs of breakage.
2.3.2
Static-free Installation
Static electricity can damage the system's electronic components. To
prevent ESD damage to any of the components, follow these
precautions before touching or handling them:
Discharge the static electricity accumulated in your body by
wearing an anti-static wristband.
Use antistatic strap during handling. Connect the equipment
end of the strap to an unfinished chassis surface.
Avoid carpets, plastic, vinyl, and styrofoam in your work area.
If the need should arise for carrying system modules from
one place to another, carry them in a static shielding
container.
Avoid contact between circuit boards and clothing.
Handle all components by holding their edges or metal
frames. Avoid touching the exposed circuitry on PCB boards
and connector pins.
2.4
General Installation Procedure
Installation Procedure Flowchart
A flowchart of the installation procedure is shown below. As you
complete each step, check off the "Done" box on the right. Please
use this flowchart in conjunction with the instructions that follow.
Chapter 2: Hardware Installation
2-7
Advertisement
Table of Contents
