Table of Contents
Advertisement
Galaxy Raid GHDX4 SAS<>-SAS/SATA 12Bay Installation / Hardware Reference Manual
Step 7.
Step 8.
2-24
6-1. Install the flash backup module by orienting and
inserting it at an approximately 15 degree angle
into the SSD socket. The SSD socket is located on
the charger board.
6-2. Make sure the SSD's golden fingers are fully
inserted. Press the SSD down. The retention clips
on the SSD socket will hold the SSD in place.
Install the RAID controller back into chassis. Insert the
controller slowly into the module slot. When you feel
the contact resistance by your hands, use more force,
and then pull both of the ejection levers upwards to
secure the controller into chassis.
Secure the controller by fastening the two (2) screws
you previously removed to the ejection levers.
Advertisement
Table of Contents
