Table of Contents
Advertisement
Step 3.
Align the drive tray with a drive bay. Gently slide it
in until the drive tray reaches the end of the drive bay.
This should be done smoothly and gently.
Step 4.
Close the front bezel. Make sure the front bezel is
closed properly to ensure that the back-end
connector is properly mated with the corresponding
connector on the backplane. If the front bezel can not
be closed properly, the connection between the hard
drive and backplane may come loose and mysterious
drive signals may result.
Step 5.
Lock the bezel into place by turning the rotary bezel
lock until the groove on its face is pointing down
(vertical orientation).
Chapter 2: Hardware Installation
Drive Tray Release Button
Installing a Drive Tray
2-21
Advertisement
Table of Contents
