Using The Remote; If The Remote Doesn't Work - Planar m52L Installation Manual

Using the Remote

Using the Remote
The remote control operates with IR (infrared) signals going to
the IR receiver (located in the lower right corner of the screen for
landscape and in the lower left corner for portrait).
(Later, to prevent accidental adjustment of the display, you can
disable the remote control function using an RS232 command.)
Note:
difficult from a distance to control only one display in an array; step
closer.

If the Remote Doesn't Work

26
The remote control has a large spread of its IR radiation. It is
• The batteries in the remote are dead or installed wrong.
• The remote was not aimed at the screen.
• Something is blocking the IR receiver in the display.
• IR remote action was disabled by an RS232 command.
m52L Installation Guide