Fujitsu control 4 0812 User Manual page 19

3. When the power is switched on, the Power indicator on the rear of the unit
will blink for 30 seconds while performing a self-test. Press the Enter key to
access the main menu.
To configure the KVM s4 Switch hardware:
1. You will see the Main menu with eleven options. Select option 1, Network
Configuration.
2. Select option 1 to set your network speed. Once you enter your selection,
you will be returned to the Network Configuration menu.
3. Select option 2 to open the IP Configuration menu.
4. Type the appropriate number to select one of the following types of IP
addresses: 1: None, 2: IPv4 Static, 3: IPv4 Dynamic, 4: IPv6 Static, or 5: IPv6
Dynamic.
5. Select options 3-5 from the Terminal Applications menu, in turn, to finish
configuring your switch for IP address, Netmask, and Default Gateway.
6. Once this is completed, type 0 (zero) to return to the main menu.
To configure the HTTP and HTTPS ports:
1. You will see the Main menu with eleven options. Select option 10, Set Web
Interface Ports to open the Web Interface Port Configuration Menu.
2. Select option 1 to set the port numbers. Type the port numbers you wish to
use for the HTTP port and the HTTPS port.
3. If the values are correct for your network, type Y and press the Enter key.
4. At the local user station, input the target device names.
Mouse Acceleration
If you are experiencing slow mouse response during a remote video session,
deactivate mouse acceleration in the operating system of the target device and
adjust mouse acceleration on each target device to Slow or None.
Web Interface Installation and Setup
Once you have installed a new switch, you can use the web interface to configure
unit parameters and launch video sessions.
Supported Browsers
The web interface supports the following browsers:
• Microsoft Internet Explorer
590-1059-640A
2.5 Configuring switches and user access to target devices
version 6.0 or later
®
13