Fujitsu control 4 0812 User Manual page 34

3. Explorer
4. For servers only, in the IP Address field, enter an IP address in dot notation
or a 1-128 character domain name. You may use either an IPv4 or IPv6 IP
address. Duplicate addresses are allowed. Spaces are not allowed.
5. In the Port field, enter a port number in the range 23-65535. If blank, port 23
is used.
6. Enable or disable the Use Default check box. When this setting is enabled,
the default global setting specified in Options will be used and all other
portions of the VNC Application to Launch area are disabled.
7. Enter the directory path and name or click the Browse button to locate the
path and name.
8. Enter command line arguments in the box below the path and name.
— or —
To insert a predefined macro at the cursor location in the command line,
click the Insert Macro list box and select a macro from the drop-down
menu. The Explorer will automatically replace these variables when the
application runs.
9. Enable or disable the Launch in command window check box. When
enabled, the user-specified VNC application will be launched from within an
OS command window.
10. Complete one of the following steps:
• Click another tab to change additional properties.
• If finished, click OK to save the new settings.
• Click Cancel to exit without saving the new settings.
RDP Properties
When you indicate a user-specified RDP application, you may include its
command line arguments. A selection of macros is available for placement in the
command line; this may be useful for automatic replacement of variables such as
IP address, port number, user name and password. For RDP commands that do
not provide their own GUI, such as those for computers running Windows, Linux
and Unix operating systems, you can launch the RDP application from within an
OS command window.
To change RDP properties:
1. Select a switch or server in the unit list.
2. Select View-Properties from the Explorer.
28
590-1059-640A