Displaying System Logging Information Using Acli - Avaya 3500 series Configuration Manual

Network monitoring configuration using ACLI

Displaying System Logging Information using ACLI

Configures information for system logging.
Procedure
1. Log on to ACLI in Privileged EXEC command mode.
2. At the command prompt, enter the following command:
Example
The following figure provides a sample of show logging command.
3524GT-PWR+#show logging
Type Time
---- ----------------------------- ---- --- -------
S 00:00:00:00
S 00:00:00:00
S 00:00:00:00
v5.0.
S 00:00:00:00
v5.0.
S 00:00:00:00
v5.0.
S 00:00:00:00
192.168.20
S 00:00:00:00
v5.0.
S 00:00:00:00
v5.0.
I 00:00:00:17
I 00:00:01:56
I 00:00:01:56
lldpXMedTopologyChangeDetected,
Class = 4
I 00:00:01:56
----More (q=Quit, space/return=Continue)----
Variable definitions
The following table describes the parameters for the show logging command.
config
32 Configuration — System Monitoring
show logging [config] [critical] [informational] [serious]
[sort-reverse] [unit <1–8>
Variable
Comments? infodev@avaya.com
Idx Src Message
1 NVR Switch IP changed
2 NVR Gateway IP changed
3 NVR Download - AGENT image
0.38 programmed successfully
4 NVR Download - AGENT image
0.40 programmed successfully
5 NVR Download - AGENT image
0.41 programmed successfully
6 NVR #1 Reset initiated through
telnet by IP address:
1.149, access mode: no security
7 NVR Download - AGENT image
0.41 programmed successfully
8 NVR Download - AGENT image
0.41 programmed successfully
9 Web server starts service on
port 80.
10 Warm Start Trap
11 Trap:
12 Trap:lldpRemTableChange Inserts =
Value
Displays local and remote system logging
configuration status
Subtype = 4
March 2013