Indoor Unit
Air Discharge Louver
Signal Receiver
Indicator Lights
Air Intake Grille
Air Filters
(Inside Air Intake Grille)
Preliminary Site Survey
•
Electrical supply and installation is to conform to local
authority's (e.g. National Electrical Board) codes and
regulations.
•
Voltage supply fluctuation must not exceed ±10% of
rated voltage. Electricity supply lines must be
independent of welding transformer which can cause
high supply fluctuations.
•
Ensure that the location is convenient for wiring, piping
and drainage.
Fig A
F
Dimension
A
1320
(5)CE 35E/ER
(52.0)
1538
(5)CE 40E/ER
(60.6)
INSTALLATION DIAGRAM
Air Intake
Air Intake Nozzle
INSTALLATION OF THE INDOOR UNIT
B
C
D
635
255
134
(25.0)
(10.0)
(5.3)
635
255
134
(25.0)
(10.0)
(5.3)
Air Intake
Standard Mounting
Ensure that the overhead supports are strong enough to hold the
weight of the unit. Position the hanger rods (wall mounting
bracket for floor standing), and check for its alignment with the
unit as shown in Figure A. Also, check that the hangers are
secured and the base of the fan coil unit is leveled in both
horizontal directions, taking into account the gradient for
drainage flow as recommended in Figure B.
A
E
E
F
1222
49
(48.1)
(1.9)
1440
49
(56.7)
(1.9)
1-4
Refrigerant piping
Outdoor Unit
All dimensions are in mm/(in)