Samsung SRP-275 Operator's Manual page 89

CHAPTER 5
CONTROL COMMANDS LIST
ESC d n
[Name] Paper cut instruction
[Format] ASCII ESC d
Hex 1B 4C
Decimal 27 64
0 ≤ n ≤ 3
[Range]
48 ≤ n ≤ 51 ("0" ≤ n ≤ "3")
[Default] ------
[Description] This command executes the auto-cut according to the n specification,
after printing data in the line buffer. After auto-cutter is executed, the printer
considers that position to be the top of the page.
Auto cutter n
0, 48
1, 49
2, 50
3, 51
5-106
n
n
n
Auto cutter
Partial cut at the current position.
This command is ignored on tear-bar models.
Partial cut at the current position.
This command is ignored on tear-bar models.
Paper is fed to cutting position, then a Partial cut is executed.
On tear-bar models, paper is fed to the tear-bar position.
Paper is fed to cutting position, then a partial cut is executed.
On tear-bar models, paper is fed to the tear-bar position.
ESC BEL n1 n2
[Name] Set external drive device 1 pulse width
[Format] ASCII ESC BEL n1 n2
Hex 1B 07 n1 n2
Decimal 27 7 n1 n2
1 ≤ n1 ≤ 127
[Range]
1 ≤ n2 ≤ 127
[Default] n1 = 20 (Energizing time: 200 msec)
n2 = 20 (Delay time: 200 msec)
[Description] Sets the energizing and delay times for drive of the external device
(such as cash drawers).
Energizing time = 10 x n1 (ms)
After printing, this is executed by BEL (External device 1 drive instruction) or
FS (External device 1 drive instruction (real time)).
This command is ignored when n1 and n2 are out of range.
- n1 = 0 or n2 = 0: This command is ignored.
- When n1 > 128: n1 = 128. When n2 > 128, n2 = 128.
5-107