Samsung SRP-275 Operator's Manual page 100

CHAPTER 5
CONTROL COMMANDS LIST
SO
[Name] Specifying the double width character/shift-out side characters
[Format] ASCII SO
Hex 0E
[Description] The data following this command is printed doubled in the horizontal direction.
Double width characters remain valid until the double width character cancel
command is entered, but they are also cancelled after they are printed one
line. Note that the double width characters take up two ordinary characters
worth of width. In the case of a serial interface, if 7-bit data is selected, the
shift-out side character is printed.
SI
[Name] Canceling the double width character
[Format] ASCII SI
Hex 0F
[Description] This command cancels the double width characters set with SO. The data
following this command are printed in the ordinary character width.
SI
[Name] Canceling the double width character/Specifying the shift-in side characters
[Format] ASCII SI
Hex 0F
[Description] This command cancels the double width characters set with SO. The data
following this command are printed in the ordinary character width. In the case
of a serial interface, if 7-bit data is selected, the shift-in side character is
printed.
5-126
(CBM2 Mode) LF
[Name]
[Format]
[Description]
CR
[Name]
[Format]
(CBM1 Mode)
[Description]
DC1
(CBM2 Mode)
[Name]
[Format]
[Description]
Printing and paper feed
ASCII LF
Hex 0A
If the print buffer contains the data, this command will feed the line after
printing. If not, the command only feeds the line.
Printing
ASCII CR
Hex 0D
This command prints the data. If the DIP switch segment 1-8 is set to OFF,
the printer will print the data in the print buffer and feed the paper by one line.
If it is set to ON, the printer will print the data in the print buffer and will not
feed the paper.
Initializing the printer
ASCII DC1
Hex 11
This command initializes the printer.
The input buffer is not cleared.
The settings of the DIP switch segments are not re-read.
(CBM1 Mode)
5-127