Samsung SRP-275 Operator's Manual page 82

CHAPTER 5
CONTROL COMMANDS LIST
ESC C n
[Name] Set page length to n lines
[Format] ASCII ESC
Hex 1B
Decimal 27
1 ≤ n ≤ 255
[Range]
[Default] 1/6 inch x 42
[Description] This command sets the length of one page to [currently set line feed
amount x n] lines.
The current position is the top position of the page.
The page length set using this command is unaffected by changing the
form feed amount later.
Moving to the top of the page is performed using the FF (Form Feed) command.
The page length setting becomes effective and the bottom margin setting
value is cleared when the page length is set to a value below the current
bottom margin setting.
ESC C NUL n
[Name] Set page length to n inches
[Format] ASCII ESC
Hex 1B
Decimal 27
1 ≤ n ≤ 127
[Range]
[Default] n = 7
[Description] This command sets the length of one page to n inches.
The current position is the top position of the page.
The page length set using this command is unaffected even if the line feed
amount is subsequently changed.
Moving to the top of the page is performed using the FF (Form Feed) command.
The page length setting becomes effective and the bottom margin setting
value is cleared when the page length is set to a value below the current
bottom margin setting.
5-92
C n
43 n
67 n
C NUL n
43 00 n
67 0 n
VT
[Name] Feed paper to vertical table position
[Format] ASCII VT
Hex 0B
Decimal 11
[Range] ------
[Default] ------
[Description] This command performs paper feeds up to the next vertical tab position after
the printer prints the data in the line buffer.
This command is ignored if there are no tabs set.
If a vertical tab is set, and the current position is the same as the vertical tab
position, or if it is below that position, it feeds paper to the top of the next page.
ESC B n1 n2 nk NUL
[Name] Set vertical tab
[Format] ASCII ESC B n1
Hex 1B 0B n1
Decimal 27 11 n1
1 ≤ n ≤ 255
[Range]
1 ≤ k ≤ 16
[Default] (Not set)
[Description] Sets the vertical tab to the (current form feed amount x n) position.
All other vertical tabs set before setting the vertical tab using this command
are cancelled.
A maximum of 16 vertical tabs can be set. However, the tab position must
satisfy the condition of 1 ≤ n1 ≤ n2... ≤ nk. When receiving the illegal codes
that do not satisfy the condition, tabs up to the illegal code are set, but those
after the illegal code are discarded up to the NUL code so illegal code tab are
not set.
The vertical tab set using this command is unaffected by changing the form
feed amount later.
All vertical tabs are cleared by inputting ESC B NUL.
When set, this is unaffected by double-high and double-high/wide character
settings.
n2 nk NUL
n2 nk 00
n2 nk 0
5-93