Connecting The Printer To A Wireless Network Using The Embedded Web Server - Lexmark CS310 Series User Manual

Additional printer setup
Launching the Wireless Setup Assistant
Notes:
•
Make sure the printer is turned on.
•
Make sure a wireless network adapter is installed in your printer and is working properly.
1
From the Finder, navigate to:
Applications > select your printer folder
2
Double‑click Wireless Setup Assistant, and then follow the instructions on the computer screen.
Note: If you encounter problems while running the application, then click

Connecting the printer to a wireless network using the Embedded Web Server

Before you begin, make sure that:
•
Your printer is connected temporarily to an Ethernet network.
•
A wireless network adapter is installed in your printer and working properly. For more information, see the
instruction sheet that came with the wireless network adapter.
1
Open a Web browser, and then type the printer IP address in the address field.
Notes:
•
View the printer IP address on the printer control panel. The IP address appears as four sets of numbers
separated by periods, such as 123.123.123.123.
• If you are using a proxy server, then temporarily disable it to load the Web page correctly.
2
Click Settings > Network/Ports > Wireless.
3
Modify the settings to match the settings of your access point (wireless router).
Note: Make sure to enter the correct SSID, security method, preshared key or passphrase, network mode, and
channel.
4
Click Submit.
5
Turn off the printer, and then disconnect the Ethernet cable. Then wait for at least five seconds, and then turn the
printer back on.
6
To verify if your printer is connected to the network, print a network setup page. Then in the Network Card [x]
section, see if the status is Connected.
?
.
23