Saving money and the environment
Use
On
Off
2
Press
.
Adjusting Sleep mode
To save energy, decrease the number of minutes before the printer enters Sleep mode. You can choose from 1 to 60
minutes. The factory default setting is 30 minutes.
Using the Embedded Web Server
1
Open a Web browser, and then type the printer IP address in the address field.
Notes:
•
View the printer IP address in the TCP/IP section in the Network/Ports menu. The IP address appears as four
sets of numbers separated by periods, such as 123.123.123.123.
•
If you are using a proxy server, then temporarily disable it to load the Web page correctly.
2
Click Settings > General Settings > Timeouts.
3
In the Sleep Mode field, enter the number of minutes you want the printer to wait before it enters Sleep mode.
4
Click Submit.
Using the printer control panel
1
From the printer control panel, navigate to:
> Settings >
2
In the Sleep Mode field, select the number of minutes you want the printer to wait before it enters Sleep mode.
3
Press
.
> General Settings >
To
Reduce printer noise.
•
Print jobs will process at a reduced speed.
•
Printer engine motors do not start until a document is
ready to print. There is a short delay before the first
page is printed.
•
The alarm control and cartridge alarm sounds are
turned off.
•
The printer will ignore the Advance Start command.
Use factory default settings. This setting supports the
performance specifications of the printer.
Note: Selecting Photo from the printer driver may disable
Quiet Mode and provide better print quality and full
speed printing.
> Timeouts >
> Sleep Mode >
86