Important Safeguards - New Buck Corporation Buck Stove FP-327-ZC Instruction Manual

Although your gas logs are very realistic in appearance, it is not a real burning fireplace and must not
be used for burning rejected material.
To avoid irreparable damage to the heater or personal injury, matches, paper, garbage, or any other
material must not be placed or thrown on top of the logs or into the flames.
To avoid personal injury, do not touch hot surfaces when the heater is operating.
Close supervision is necessary when the heater is being operated near children.
THIS HEATER IS INTENDED FOR USE AS A GAS HEATER FIREPLACE AS
DESCRIBED IN THESE INSTRUCTIONS. IT SHOULD NOT BE USED FOR
ANY OTHER PURPOSE.
CAUTION:
OTHER PARTS OF THE HEATER, BE SURE TO READ THE ABOVE
SECTIONS ON IMPORTANT SAFEGUARDS.
All cleaning should be carried out when the heater is cold. Limited cleaning is required with normal
use. Dusting the front of the base, the top of the piezo cover, or the control knob panel may be
required occasionally. Do not use cleaning fluids to clean the logs or any other part of the heater.
If the flames show unusual shapes or behavior, or if burner fails to ignite properly, the burner holes
may require cleaning. If this occurs, contact your nearest dealer to service the heater.
The heater can be cleaned by removing the top, front, and rear logs. Handle each log gently, as not to
damage the logs. Lift each log by holding it carefully at each end. Use a vacuum cleaner to remove
dust and loose particles from the base, logs and around the burner and ODS/Pilot.

IMPORTANT SAFEGUARDS

WARNING:
CLEANING
BEFORE CLEANING OR MOVING THESE LOGS OR
Page 32