Table of Contents
Advertisement
WITH OPTIONAL WOODEN MANTEL
(1) When choosing the right location for your heater and mantel keep the following in mind:
NOTE:
Due to high temperatures, this heater should be located out of traffic areas and away
from furniture and draperies.
NOTE:
Kit No. (PAKDM327) Optional Wooden Mantel for FP-327-ZC.
CAUTION:
THE INSTALLATION MUST CONFORM WITH LOCAL CODES OR, IN
THE ABSENCE OF LOCAL CODES, WITH THE NATIONAL FUEL GAS CODES, ANSI
Z223.1/NFPA 54.
NOTE:
See page 18 for "Gas Connection" and page 19 for "Gas Pressure Check".
WARNING: YOUNG CHILDREN SHOULD BE CAREFULLY SUPERVISED WHEN THEY
ARE IN THE SAME ROOM WITH THE APPLIANCE.
DO NOT PLACE CLOTHING OR OTHER FLAMMABLE MATERIAL ON OR NEAR THE
APPLIANCE
(2) Screen(s) can not be removed or altered (Position screen(s) in the closed position before leaving
heater unattended).
(3) Follow instructions for assembly of (Optional) Wooden Mantel. See instructions supplied with
mantel.
(4) After mantel has been assembled, slide the heater from the rear into the opening of the mantel.
NOTE:
Place a cloth or blanket over the front portions of the mantel as not to scar the wood.
(5) Center the heater in the opening of the mantel. See Figure 6.
(6) Fasten mantel to hearth by using 1/2" wood screws.
(7) Insert the nine (9) wood screws provided with mantel through slots on nailing flange and secure in
place. See Figure 6.
(8) Position mantel and fireplace into desired location.
NOTE: Hook gas supply line into heater. Check for leaks using soap and water, not an open flame.
NOTE: At this point, you may want to anchor the mantel to the wall or floor.
(9) Now you are ready to position the log set.
INSTALLATION OF MODEL
FP - 327- ZC
Page 11
Hide quick links:
Advertisement
Table of Contents
