Wiring Diagram - New Buck Corporation Buck Stove FP-327-ZC Instruction Manual

WARNING:
HAZARDS OF HIGH SURFACE TEMPERATURES AND SHOULD STAY AWAY TO
AVOID BURNS OR CLOTHING IGNITION.
CAREFULLY SUPERVISED WHEN IN THE SAME ROOM AS GAS LOGS.
WARNING:
BE PLACED ON OR NEAR THESE GAS LOGS.
NOTE: If any of the original wire as supplied with the gas appliance must be replaced, it must be
replaced with type 16ga., 105
NOTE: The blower assembly is standard for this appliance, and is installed by the
manufacture.Installation and repair should be done by a qualified service person. This heater
should be inspected before use and at least annually by a qualified service technician. More
frequent cleaning may be required due to excessive lint from carpeting, bedding material,
etc. It is imperative that control compartments and circulating air passageways of the heater
be kept clean.
CAUTION: Label all wires prior to disconnection when servicing controls. Wiring errors can cause
improper and dangerous operation.
Verify proper operation after servicing.
CHILDREN AND ADULTS SHOULD BE ALERTED TO THE
CLOTHING OR OTHER FLAMMABLE MATERIAL SHOULD NOT

WIRING DIAGRAM

JUMPER
MOTOR
JUMPER
WHITE
GREEN
POWER CORD
Figure 15
o
C. rating wire or its equivalent.
YOUNG CHILDREN SHOULD BE
THERMOSTAT
JUMPER
BLACK
BLACK
Page 30
RHEOSTAT