Important Instructions - New Buck Corporation 21NC Preparations, Installation, Operation, Maintenance, Safety

Fireplace insert & freestanding non-catalytic unit
Table of Contents

Advertisement

INSTALLATION AND OPERATION
THESE UNITS GENERATE A LOT OF HEAT, SO TREAT THEM WITH CARE. HOT
WHILE IN OPERATION. KEEP CHILDREN, CLOTHING AND FURNITURE AWAY.
CONTACT MAY CAUSE SKIN BURNS. READ ALL INSTRUCTIONS BEFORE
INSTALLING AND USING THE APPLIANCE. FAILURE TO FOLLOW
INSTRUCTIONS MAY RESULT IN PROPERTY DAMAGE, BODILY INJURY OR
EVEN DEATH. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCES.
The New Buck Corp. non-catalytic systems have been tested to UL 1482 Standards and
certified by PFS/TECO.
NOTE: When burning any unit or appliance that combusts fuel for heat, such as
coal, oil, wood or natural and (L.P.) liquid petroleum gas, we highly recommend
use of smoke and carbon monoxide detectors in your home.
Early signs of carbon monoxide poisoning resemble flu, with headaches, dizziness and/or
nausea. If you have these signs, heater may not be working properly. Get fresh air at once!
Install and operate your units according to instructions provided in this manual. Local
building codes may apply; therefore, contact your local building inspector or fire marshal
for necessary installation requirements and permits which may go beyond these
instructions. The authority having jurisdiction should be consulted before installation to
determine the need to obtain a permit. Contact your insurance company for coverage and
installation inspection.
If appliance is installed in permanently manufactured homes:
DO NOT INSTALL IN SLEEPING ROOMS.
NOTE: When burning any unit or appliance that combusts fuel for heat, such as
coal, oil, wood or natural and (L.P.) liquid petroleum gas. Correctly place monitors
in those areas that are expected to produce CO. Consult with your local fire safety
officials to learn more
The Model 21 is approved for use in specified Pre-Fabricated fireplaces (ZCF's). Use the
list on Page 11 or contact your dealer for additional units.
Examine the masonry fireplace and chimney prior to installation of the fireplace accessory
to determine that the construction meets the minimum fireplace construction requirements
illustrated in the instructions, that it is free from cracks, loose mortar, creosote deposits
and other blockage or other signs of deterioration.
DO NOT USE MORE THAN ONE STOVE TO A CHIMNEY. DO NOT USE A FLUE
INTENDED FOR A GAS APPLIANCE. DO NOT CONNECT THIS UNIT TO A
CHIMNEY FLUE SERVING ANOTHER APPLIANCE. DO NOT CONNECT TO ANY
AIR DISTRIBUTION DUCT OR SYSTEM.
READ THIS FIRST

IMPORTANT INSTRUCTIONS

WARNING
CAUTION
Page 2

Advertisement

Table of Contents
loading

This manual is also suitable for:

21Zc21

Table of Contents