Vend Price #2 "Ats2 - ALLIANCE BF3LLFSG401UN01 Programming Manual

13. Vend Price #2 "AtS2"

This option allows the owner to set the vend price for a
NORMAL 60 wash. This vend price will be shown in
the display when NORMAL 60 is selected.
How to Program the Vend Price #2
1. Control must be in Manual Mode. Refer to
Entering the Manual Mode.
2. Press the NORMAL 40 ( ) or the DELICATES
COLD ( ) keypad until "Prog" appears in the
display. Press the START (enter) keypad, and
"AtS1" will appear in the display.
3. Press the NORMAL 40 ( ) or the DELICATES
COLD ( ) keypad to scroll through the
programmable options until "AtS2" appears in
the display. The NORMAL 60 LED will be lit to
show which cycle/temperature price is being
programmed.
4. When "AtS2" appears in the display, press the
START (enter) keypad. There are five digits in
the Vend Price #2. The fifth digit will appear in
the display and will flash one second on, one
second off. Refer to Figure 14.
NOTE: If the vend price is 10000 or more, the fifth
digit is "1-6". If the vend price is 9999 or less, the
fifth digit is "0".
Figure 14
© Published by permission of the copyright owner – DO NOT COPY or TRANSMIT
802953
5. Press the NORMAL 40 ( ) or the DELICATES
COLD ( ) keypad to increase or decrease the
value of the fifth digit.
NOTE: The vend price can be set from 0 to 65,535.
The factory default setting is 200.
6. Press the START (enter) keypad to enter the fifth
digit and display remaining four digits. The
active digit will flash one second on and one
second off.
NOTE: To go back to the current programmable
option without changing the value, press the
DELICATES 30 (<) keypad.
7. Press the NORMAL 40 ( ) or the DELICATES
COLD ( ) keypad to increase or decrease the
value of the active digit and the START (enter)
keypad to enter the value of the digit and advance
to the next digit.
8. Press the START (enter) keypad with the last
active digit. The next option, "AtS3", will appear
in the display.
NOTE: To program "AtS3" (Vend Price #3), refer
to option 14. To program other options, refer to the
appropriate section.
How to Exit Programming Feature
Press the DELICATES 30 (<) keypad until the control
returns to Ready Mode.
CHM507R
Programming Control
43