Routing The Engine Starter Harness - Honda 08E91-E22-101B Installation Instructions Manual

Routing the Engine Starter Harness

37. Route the engine starter harness as shown.
DRIVER'S LOWER
COVER OPENING
38. Using isopropyl alcohol on a shop towel, thoroughly
clean the areas where the 40A fuse labels and the
3A fuse label will attach.
RELAY
3A FUSE
LABEL
39. Attach the 40A fuse labels and the 3A fuse labels to
the relay block and the fuse case of the engine
starter harness.
40. Plug the three relays into the relay block of the
engine starter harness.
12 of 28
ENGINE STARTER
921304BD
HARNESS
RELAY
FUSE
BLOCK
CASE
40A FUSE
LABEL
ENGINE STARTER
HARNESS
921305BD
41. Unlock the vehicle 42-pin connector by pushing the
retaining tab on the connector, and unplugging the
connector from the fuse box.
VEHICLE
42-PIN
CONNECTOR
RETAINING
TAB
VEHICLE 4-PIN
CONNECTOR
42. Unplug the vehicle 4-pin connector and the 2-pin
connector from the top of the fuse box as shown.
43. Wrap two urethane tapes around the vehicle 4-pin
connector and the 2-pin connector.
VEHICLE
4-PIN AND 2-PIN
CONNECTORS
44. Secure the vehicle 4-pin connector and 2-pin
connector to the vehicle harness using a wire tie.
AII 44367 (1008)
VEHICLE 4-PIN
VEHICLE 2-PIN
CONNECTOR
CONNECTOR
URETHANE TAPE
© 2010 American Honda Motor Co., Inc. – All Rights Reserved.
Push.
VEHICLE
2-PIN
CONNECTOR
FUSE
BOX
921306AD
VEHICLE
HARNESS
WIRE
TIE
921307AD