Table of Contents
Advertisement
3.
Touch the metal part of the screwdriver to any metal
part of the vehicle to discharge any static electricity.
CONTROL
SMALL FLAT-TIP
UNIT
SCREWDRIVER
SWITCHES
SWITCHES
SW:1 RR Junction unit -------------------- > OFF
SW:2 Trunk or Tailgate -------------------- > ON
SW:3 Smart Entry --------------------------- > OFF
SW:4 Horn or Buzzer Answerback ---- > OFF
SW:5 Trunk Main SW ----------------------- > OFF
SW:6 Reserve--------------------------------- > OFF
4.
Check the settings of the switches on the control
unit.
NOTE:
•
The switches must be set before the control unit
is plugged in.
•
If the switch settings are not correct, the remote
engine starter will not operate correctly.
•
If you change the switch settings with the unit
connected, you must disconnect the unit, then
reconnect it before the control unit recognizes
the new settings.
5.
Using a small flat-tip screwdriver, adjust the switches
on the control unit as shown.
© 2010 American Honda Motor Co., Inc. – All Rights Reserved.
6.
Discharge any
static electricity.
SET
Removing the Vehicle Parts
7.
921301AD
AII 44367 (1008)
Using isopropyl alcohol on a shop towel, thoroughly
clean the area where the protective tape will attach.
Remove the backing from the protective tape. Attach
the protective tape to the control unit over the
switches.
SWITCHES
PROTECTIVE
TAPE
BACKING
Remove the right and left map light lenes (four
retaining tabs each). Do not damage the lenses.
4 RETAINING
TABS
LEFT MAP
LIGHT LENS
RIGHT MAP
LIGHT LENS
CONTROL
UNIT
Clean.
772505AS
ROOF CONSOLE
4 RETAINING
TABS
PLASTIC TRIM
TOOL
802001AD
5 of 28
Hide quick links:
Advertisement
Table of Contents
