Honda 08E91-E22-101B Installation Instructions Manual page 22

100. Remove the tape and plug the hood switch harness
2-pin connector into the engine starter harness 2-pin
connector. Secure the connector to the vehicle
harness with one wire tie.
TAPE
WIRE
TIE
PLUGGED
CONNECTORS
HOOD SWITCH
HARNESS
22 of 28
ENGINE STARTER
HARNESS
ENGINE
STARTER
HARNESS
2-PIN
CONNECTOR
HOOD SWITCH
HARNESS 2-PIN
921707BD
CONNECTOR
AII 44367 (1008)
101. Plug the engine starter harness 28-pin connector
and antenna cable into the control unit as shown.
ENGINE STARTER HARNESS
28-PIN CONNECTOR
DRIVER'S
LOWER
COVER
DRIVER'S
UNDER
COVER
ANTENNA
CABLE
102. Reinstall the driver's lower cover and the driver's
under cover.
103. Using isopropyl alcohol on a shop towel, thoroughly
clean the area where the caution label will attach.
HOOD
104. Attach the caution label to the hood.
© 2010 American Honda Motor Co., Inc. – All Rights Reserved.
ANTENNA
CABLE
CONTROL
UNIT
CONTROL
UNIT
ENGINE STARTER HARNESS
28-PIN CONNECTOR
ADHESIVE
BACKING
CAUTION
LABEL
6D2401AK