Russound CP 4.6 Instruction Manual page 36

7. With one of the CP4.6s with Zone 1 selected, change sources on the front panel.
The source change should be seen on both CP4.6s.
8. Set the other CP4.6 for Zone 2, change sources on the front panel. The source
change should be seen on both CP4.6s.
9. Press the Party Mode button twice on one of the CP4.6s, both units should now
return to normal operation.
10. Press Memory then All Off to clear all presets.
Ground Test:
1. Ensure the Assembly Department attached the "Ground Symbol" sticker on the
inside of the rear panel, to the right of the "Ground Stud" near the AC receptacle.
See model for example.
2. Disconnect power and any accessories and/or additional CP4.6s that are
connected.
3. With the cover removed, test continuity from the ground terminal of the power
input connector to the following points.
a. Ground terminal of the 3-prong AC outlet.
b. Ground lug on the power supply.
c. Chassis main ground screw.
d. Chassis.
e. Power supply screw.
f. Ground plane on PCB.
Hi-Pot Test:
From TUV.
As for the Hi pot test requirement, the value is 1500VAC (2121VDC) between phase/
neutral and chassis (ground) for 1 sec. Also, a ground continuity test needs to be
performed between ground and chassis at 25A for 1 sec.
Cover:
1. Inspect cover for CP4.6.
2. Attach cover.
Labels:
1. Affix the manufacturers Serial # on the back of the CP4.6. Place the Revision
sticker and date sticker on the bottom of the CP4.6.
2. Perform the Test Departments assembly procedure.
THE TEST PROCEDURE IS COMPLETE.
Poe
Last Updated: 6/14/01
13