Table of Contents
Advertisement
6. Press the SPG Keypad button and speak into the Keypad. You should be able to
hear your voice over the speakers.
7. Check the Page Trigger Output on the back of the CP4.6. There should be
12VDC, every time a page is initiated. Test: The LED on the 12Volt LED
Indicator should light every time a page is initiated.
8. Connect the SPG Keypad to Zone 3,4 and Page All. Repeat steps (6. through 7.).
9. The page should be heard through all Zones except the one where the page
originates.
Perform Page/Memory/Preset and Paging for Variable Zone Outputs 2,3 and 4.
Video Test:
1. Press the ALL ON button on the CP4.6. All four zone LEDs should light up.
2. Connect the Right Side of the line level source to the Source 1 Video Input. Test:
Connect the Right Side of the "Zone 2 ADP-1" to the Source 1 Video Input on the
CP4.6.
3. Take the cable connected to the Right Zone 1 Output and move it to the Zone 1
Video Output.
4. Select Source 1 on Zone 1 on the front panel.
5. The music should be heard through one of the speakers.
6. Move the Right Side of the line level source to the Source 2 Video Input. Test:
Connect the Right Side of the "Zone 2 ADP-1" to the Source 2 Video Input on the
CP4.6.
7. Select the Source 2 on Zone 1 on the front panel.
8. The music should be heard through one of the speakers.
9. Perform steps (2. through 8.) for Source Inputs 3 through 6.
10. Perform the Video Test steps (2. through 8.) for Zones 2, 3 and 4.
Memory Zone Lock Out:
1. Press the ALL OFF button.
2. Starting with the CP4.6 Zone 1 selected, press the Memory button. The memory
indicator will light.
3. Press the ALL ON button. None of the lights should turn on.
4. Press the Memory button.
5. Press the ALL OFF button.
6. Repeat steps (1. through 4.) for Zones 2, 3 and 4.
7. Press the ALL ON button. None of the lights should turn on.
8. Starting with Zone 1, press the Memory button. The memory indicator will light.
9. Press the PRESET button.
10. Press the MEMORY button.
11. Repeat steps (7. through 9.) for Zones 2, 3 and 4.
12. Press the ALL ON button. All four zone indicator lights should turn on.
11
Advertisement
Table of Contents
