Russound CP 4.6 Instruction Manual page 33

5. Set Zone 1 to Source 1.
6. Press The Party button once, the Source/Volume Link indicator will light.
7. Zones 2, 3, and 4 should now be on Source 1.
8. Set the CP4.6 for Zone 4 by selecting the Zone 4 button. Change the source to
Source 2. Set the CP4.6 back to Zone 1, the source should now be set for Source
2.
9. Press The Party button again, the Source/Volume Link indicator should light.
10. Attach the PCK-IR Keypad to Zone 2 on the CP4.6. Change the volume from the
PCK-IR Keypad. Change the source from the Keypad. Both the volume and
source should change from the Keypad.
11. Press The Party button again the Source/Volume Link indicator should no longer
be lit.
Page/Memory/Preset:
1. With the CP4.6 set for Zone 1 perform the following steps on the CP4.6.
2. Set the Volume for a comfortable setting.
3. Press the Memory button, the memory LED should light.
4. While the Memory indicator is lit press the following button Volume Down.
5. Press the Memory button, the memory LED should no longer be lit.
6. The Preset Paging volume is now set.
Paging:
1. Ensure the Audio is being heard through Zone 1 on the CP4.6. Test: Ensure the
Tuner is being heard through the CP4.6.
2. Connect a SPG Paging module to the Zone 1 page input. Test: Attach the Test
SPG Paging module to the page input for Zone 1.
Figure 9.
3. Press the SPG module button and speak into the Keypad. You should not be able
to hear your voice over the speakers. The line level audio source (Tuner) will not
be heard when the button is pressed.
4. Connect a SPG Paging module to the Zone 2 page input. Test: Attach the Test
SPG Paging module to the page input for Zone 2.
5. Test: Connect the 12Volt LED Indicator to the Page Trigger Output.
10