Russound CP 4.6 Instruction Manual page 27

12Volt Trigger Out Test:
1. Turn on all zones by pressing "ALL ON" on the front of the CP4.6. All four zone
LEDs on front panel should illuminate. Check the Common 12Volt Trigger Out
on rear panel, there should be 12VDC. Check the 12Volt Trigger Outputs (4),
there should be 12VDC at each output. Test: Check the Common 12Volt
Trigger Out on rear panel with the 12Volt LED Indicator. The LED should
illuminate. Check the 12Volt Trigger Outputs (4) on rear panel, again the LED
should illuminate.
2. Turn off all zones by pressing ALL OFF on the front of the CP4.6. All zone
LEDs on front panel should turn off. Check the Common 12Volt Trigger Out,
there should not be 12VDC. Check the 12Volt Trigger Outputs (4), there should
not be any voltage. Test: Check the common 12Volt Trigger Out, with the
12Volt LED Indicator. The LED should not illuminate. Check the 12Volt
Trigger Outputs (4) on rear panel, none of the individual zone 12Volt Trigger
Outputs should illuminate.
Zone Test:
1. Connect a line level audio source to the Source 1 Left and Right Input, an
amplifier to the Variable Zone Output 1 on the CP4.6. Connect speakers to the
amplifiers output. Test: Attach the "Zone 2 ADP-1" line level output to the
Source 1 Left and Right Input on the CP4.6. Ensure the line level audio source
(Tuner) is turned on and producing a clear signal. Attach the amplified speakers
to the connector labeled speakers and ensure the speakers are set at halfway. The
speaker on the right should have the volume and on/off switch on the rear. Attach
the DPA 1.2 to the Variable Zone Output 1.
2. Attach a PCK-IR Keypad to the Keypad Input for Zone 1. Test: Attach the Test
PCK-IR Keypad to the Keypad Input for Zone 1.
Figure 3.
4