Russound CP 4.6 Instruction Manual page 31

Disconnect the Right Side of the "Zone 2 ADP-1" output from the Source 1 input.
Listen to ensure the Audio is only being heard in one speaker.
7. Reconnect the Right Side of the line level source output to the Source 1 input.
Test: Reconnect the Right Side of the "Zone 2 ADP-1" output to the Source 1
input.
8. Disconnect the Left Side of the line level source output from the Source 1 input.
Listen to ensure the line level source is only being heard in one speaker. Test:
Disconnect the Left Side of the "Zone 2 ADP-1" output from the Source 1 input.
Listen to ensure the Audio is only being heard in one speaker.
9. Reconnect the Left Side of the line level source output to the Source 1 input.
Test: Reconnect the Left Side of the "Zone 2 ADP-1" output to the Source 1
input. Listen to ensure that the Audio is heard through both speakers.
10. Connect the Right Side of the line level audio source to the Source 1 Video Input.
Disconnect the Left Side of the line level audio source from the CP4.6. Attach
the Right Side of the amplifier to the Source Loop 1 Video Output. Disconnect
the Right Side of the amplifier from the CP4.6. Test: Connect the Right Side of
the "Zone 2 ADP-1" to the Source 1 Video Input on the CP4.6. Disconnect the
Left Side of the "Zone 2 ADP-1 from the CP4.6. Attach the Right Side of the
DPA 1.2 to the Source Loop 1 Video Output. Disconnect the Left Side of the
DPA 1.2 from the CP4.6.
11. The music should be heard through the right speaker.
12. Perform steps (1. through 11.) for Source Inputs 2 through 6.
Figure 8.
Fixed/Video Zone Output Test:
Note: There are only four "Fixed Zone Line Outputs" on the CP4.6, while there are six
"Source Loop Outputs". The four "Fixed Zone Line Outputs" are labeled at the top in
gold coloring while the six "Source Loop Outputs" are labeled at the bottom.
1. Connect the line level audio source to Source 1 input. Test: Attach the "Zone 2
ADP-1" Line Level Output to the Source 1 Input on the CP4.6.
2. Attach the amplifier to the Fixed Zone Line Out 1 on the CP4.6. Test: Attach the
DPA 1.2 to the to Fixed Zone Line Out 1.
8