Russound CP 4.6 Instruction Manual page 29

Note: Steps 3 through 10 should be done on the CP 4.6.
3. Turn Zone 1 on by pressing ON/OFF, the Zone 1 LED should illuminate.
4. Press VOLUME UP the volume should increase. The increase should be heard
through both speakers.
5. Press VOLUME DOWN the volume should decrease. The decrease should be
heard through both speakers.
6. Press BASS UP the bass should increase.
7. Press BASS DOWN the bass should decrease.
8. Press TREBLE UP the treble should increase.
9. Press TREBLE DOWN the treble should decrease.
10. Press LOUDNESS there should be an audible enhancement of both bass and
treble. The LOUDNESS LED should be illuminated. Press LOUDNESS again
the effect should go away and the LED should no longer be illuminated.
11. Apply 12VDC to the Mute Input on the back of the CP4.6. The "Line Level
Audio Source" should no longer be heard. Test: Connect an 846 Power Supply
to the Mute Input. The "Line Level Audio Source" should no longer be heard.
12. Disconnect the 12VDC from the Mute Input, the "Line Level Audio Source"
should return to its previous levels and be heard. Test: Disconnect the 846
Power Supply from the Mute Input. The "Line Level Audio Source" should
return to its previous levels and be heard.
13. Change sources on the Keypad. Ensure the source-selected changes on the CP4.6.
14. Change sources on the CP4.6. Ensure the source-selected changes on the Keypad.
Memory/Preset Test:
1. Connect the line level audio source to Source 1 input. Test: Attach the "Zone 2
ADP-1" Line Level Output to the Source 1 Input on the CP4.6.
2. Attach the amplifier to the Variable Zone Output 1 on the CP4.6. Test: Attach the
DPA 1.2 to the to Variable Zone Output 1.
3. With the CP4.6 set for Zone 1 perform the following steps.
4. Set the Volume, Bass, Treble, and Loudness for comfortable settings.
5. Press the Memory button, the memory LED should light.
6. While the Memory indicator is lit press the following buttons: Source 1, Volume
Up, Bass up, Treble Up, and Loudness.
7. Press the Memory button, the memory LED should no longer be lit.
8. Select Source 2, Volume all the way down, Bass all the way down, Treble all the
way down, Loudness off.
9. Press the Preset button on the front panel. Zone 1 should now reflect the same
settings as set in step (2.).
10. Press Memory then Preset and then Memory. This clears the Memory Preset.
Source Input Test:
1. The line level source should be attached to the Source 1 input. The 845.1 should
be connected to the Common IR Output. Test: The "Zone 2 ADP-1" should be
attached to the Source 1 input. The 845.1 should be connected to the Common IR
6