Russound CP 4.6 Instruction Manual page 25

Equipment Needed: Line Level Audio Source (Tuner)
Inspection: Inspect Sheet Metal for scratches
Inspect screening for correct labeling.
Turn on unit with ON/OFF power switch
Start Up:
1. Test: Confirm the Speakers are either not connected to the DPA 1.2 or are in the
off position.
2. Connect the Power Cord (09-0504) to the back of the CP4.6 and the other end to
an AC outlet.
Turn on the unit by pressing the ON/OFF switch on the front top left of the unit.
Front Panel Test:
Note: All four zones should be off when the CP4.6 is first turned on. Refer to figures 1,2
and 3 for button assignment.
1. ON/OFF – Turn on Zone 1 by pressing the ON/OFF button on the front panel
then turn it off. Turn Zone 1 back on. The ON/OFF light for that zone should
turn off and back on.
2. SOURCE LIGHTS – Press each of the six source buttons. Each source light
should light as soon as the button is pressed and the previous light should go off.
3. LOUDNESS – Turn on and off loudness. The loudness light should turn on and
off on the front panel.
4. MEMORY/PRESET – Press MEM, Memory light (green) should light. Press
MEM again, Memory light should go off.
5. PARTY MODE – Press PARTY, Red Source Link light should light. Press
PARTY again, Green Source/Volume Link light should light. Red Source Link
light should go out. Press PARTY again, Green Source/Volume Link light should
go out. Neither light should be lit.
CP4.6
CP4.6 Diagnostic Program
Speakers
CP4.6 Instruction Manual
12Volt LED Indicator (1/8 inch jack, LED, 1K ohm resistor)
IR LED Indicator
2 845.1
Amplifier
PCK-IR
SPG
DPA 1.2
Power Cord (09-0504)
DB-25 Cable
RS-232 Cable
2