Table of Contents
Advertisement
Output. Attach the IR LED Indicators to the all Source 1 Emitter Outputs. The
Test PCK-IR Keypad should still be attached to the Zone 1 Keypad input.
2. Control Source 1 component with the remote from the PCK-IR Keypad. Ensure
the source can be controlled from both the Common IR Output and the Source IR
Output. Test: Control the Tuner with the remote from the PCK-IR Keypad.
Ensure the IR LED Indicator that is attached to the Source 1 Emitter Output is
blinking when the remote is activated.
3. Disconnect the Right Side of the line level source output from the Source 1 input.
Listen to ensure the line level source is only being heard in one speaker. Test:
Disconnect the Right Side of the "Zone 2 ADP-1" output from the Source 1 input.
Listen to ensure the Audio is only being heard in one speaker.
4. Reconnect the Right Side of the line level source output to the Source 1 input.
Test: Reconnect the Right Side of the "Zone 2 ADP-1" output to the Source 1
input.
5. Disconnect the Left Side of the line level source output from the Source 1 input.
Listen to ensure the line level source is only being heard in one speaker. Test:
Disconnect the Left Side of the "Zone 2 ADP-1" output from the Source 1 input.
Listen to ensure the Audio is only being heard in one speaker.
6. Reconnect the Left Side of the line level source output to the Source 1 input.
Test: Reconnect the Left Side of the "Zone 2 ADP-1" output to the Source 1
input. Listen to ensure that the Audio is heard through both speakers.
7. Move the line level audio source to Source 2 and repeat steps (1. through 6.).
Repeat for all sources. Test: Move the "Zone 2 ADP-1" to Source 2 and repeat
steps (1. through 6.). Repeat for all sources.
Perform the Zone Test, Memory/Preset Test and Source Input Test for Variable
Zone Outputs 2,3 and 4.
Source/Video Loop Output Test:
Note: There is only four "Fixed Zone Line Outputs" on the CP4.6, while there is six
"Source Loop Outputs". The four "Fixed Zone Line Outputs" are labeled at the top in
gold coloring while the six "Source Loop Outputs" are labeled underneath of the RCA
jacks on the rear of the CP4.6.
1. Connect the line level audio source to Source 1 Input. Test: Attach the "Zone 2
ADP-1" Line Level Output to the Source 1 Input on the CP4.6.
2. Attach the amplifier to the Source Loop Output 1 on the CP4.6. Test: Attach the
DPA 1.2 to the to Source Loop Output 1.
3. Put the "A-Bus" Ready switches (4) on the rear of the CP4.6 in the "Source Loop
Out" position.
4. Ensure that Zone 1 on the front panel is selected to Source 1.
5. The audio from the line level audio source (Tuner) should be heard through both
speakers.
6. Disconnect the Right Side of the line level source output from the Source 1 input.
Listen to ensure the line level source is only being heard in one speaker. Test:
7
Advertisement
Table of Contents
